# Connecting to a Driver
Depending on the type of LED Tape or Linear Bar you are using, you will need to wire it to the SRPC2108 in different ways. You will also need to configure the SRPC2108 in different ways.
Here is a chart explaining which pins to connect to on a SRPC2108 and which configuration to set for a SRPC2108.
| Driver Pin & configuration | + | 1- | 2- | 3- | 4- | CH | DP |
|---|---|---|---|---|---|---|---|
| LED Tape | |||||||
| White Only | Power Wire | Negative Wire | 01 | 1.1 | |||
| Bi-White | Power Wire | Warm White | Cold White | 02 | 3.2 | ||
| RGB | Power Wire | Red | Green | Blue | 03 | 4.3 | |
| RGBW | Power Wire | Red | Green | Blue | White | 04 | 5.4 |
Note
Make sure to check the soldering pads to see which one powers what color. Wire color may differ.
# Wiring Pictures
# White 144 tape light wiring
# RGB tape light wiring:
# RGBW tape light wiring:
# Bi-white tape light wiring:
